Filter
Top Products
72
Taking Pictures
4
You can switch the drive mode to the Remote Control mode and take
pictures using the remote control unit E or F (optional).
1 Press the gh button in the
Capture mode to display
i or h
on the LCD monitor.
The self-timer lamp blinks slowly and the
camera is ready to take pictures.
2 Press the shutter release button
on the remote control unit.
i The self-timer lamp blinks quickly and the picture is taken after
approximately three seconds.
h The picture is taken immediately.
Life of the Battery for the Remote Control Unit
A signal can be sent from the remote control unit to the camera
approximately 30,000 times. Contact your nearest PENTAX customer
service center if the battery needs changing. (A charge is required for
changing the battery.)
Using the Remote Control Unit (optional)
Focusing may be compromised if you move the camera while the
self-timer lamp is blinking.
• The buttons on the camera can be used in the normal way.
• Ensure that the remote control unit is no more than four meters
away from the front of the camera.
gh button
3:00 PM
3:00 PM
7/ 7/2004
7/ 7/2004
3:00 PM
7/ 7/2004