Filter
Top Products
86
Taking Pictures
4
When the mode is set to the
z
(Manual Focus) mode, a frame appears in
the center of the display. Then press the four-way controller (
23
) to enlarge
the frame to full screen and display the indicator. Use the four-way controller
(
23
) to adjust the focus while watching the indicator on the LCD monitor.
After the focus is set, press the OK button or take your finger off the four-
way controller (
23). The screen returns to the normal display about two
seconds later.
• The default setting is the Autofocus mode.
• The zoom is fixed at the wide-angle position in the Super Macro
mode.
• The Focusing Area mode cannot be selected in the Movie (
1p.56)
and 3D Image (
1p.60) modes.
• The flash will not discharge in the Super Macro and Infinity-
Landscape modes.
• The Focus Limit setting is saved when the focus mode is changed.
If you take a picture while looking through the viewfinder when the
focus mode is set to the Macro or Super Macro, the range of the
resulting picture will differ from what was seen in the viewfinder. Be
sure to check the image on the LCD monitor.
Manual Focus
For distant focus
For closer focus
When focusing, hold down the four-way controller (23) to focus
quickly.
2m
2m
0.6
0.6
7/ 7/2004
7/ 7/2004
3:00 PM
3:00 PM
2m
0.6
046
046
046
7/ 7/2004
3:00 PM
Indicator