Filter
Top Products
4.3 Set Up Device ID Number
To build correct network for control communication, every speed dome camera in
the network must have an unique ID number
, which is set by the bit 1 to 8 of a
8-bit DIP switch DS2.
Note: Factory default of device ID is 1
Find 8-bit DIP switch DS2 on the PC board
DS2
Bit number
remark: Dash line “---“ in table means to
set the bit to “OFF” position
Refer to the tables in the next two pages for ID setting (the tables will show the
relation between pin assignments of DIP switch and ID numbers 1 to 128)
Since the highest ID of this camera is 128, maintain the bit number 8 in OFF
position all the time.
All the speed domes in a network must have their unique ID. It is highly
recommended to installers, for future maintenance and users’ convenience, to
mark the ID of each camera onto its corresponding location on the site map,
and make out a list of cameras with their ID numbers.
The DS2 pin assignment for ID setup is in binary format.
. .
User’s manual 9