Filter
Top Products
First-Time Operation (continued)
9
2. Attach a power supply to the camcorder.
Attach a power supply to the camcorder–either
the adapter/charger or charged battery.
Adapter/Charger
Connect one end of the DC power cord into the
DC OUT jack on the adapter/charger. Plug the
other end of the DC power cord into the DC IN
6.5V jack on the back of the camcorder. Plug the
adapter/charger’s plug into an operating outlet.
The POWER indicator on the adapter/charger will
light. Details are on page 16.
Charged Battery*
Make sure the camcorder’s POWER switch is in
the OFF position. Match the line on the battery
to the line on the camcorder. Hold the battery
flush against the camcorder and slide it in the
direction of the arrow until a click is heard.
Details are on page 17.
*The battery must be charged before it can be used the
first time.
POWER
CHARGE
REFRESH
ON
POWER
SAVE
DC IN 6.5V
START/
STOP
REC
ADJ.
POWER
DATE/TIME RES. MEM
COUNTER
OPEN
DC OUT
Jack
DC IN 6.5V
Jack
Attach charged battery
to camcorder.
POWER
Indicator Jack
To AC 100-240V,
50/60 Hz
DC Power
Cord
(continued on next page)
3. Remove the lens cap and attach it to
the lens cap holder on the camcorder.
Pull on the tab on the side of the lens cap to
remove it. Then pull it straight, rotate it down,
and attach it to the lens cap holder on the side of
the camcorder.
4. Attach the shoulder strap.
1.Unfasten one end of the shoulder strap from the
buckle. Make sure you leave the buckle on the
strap.
2.Thread one end of the shoulder strap through
one of the shoulder strap rings (located on the
top and bottom of the camcorder).
3.Thread the strap back into the buckle. Pull on
the strap and make sure it is securely fastened
before using the shoulder strap to support the
camcorder.
4.Repeat steps 1-3 for the other end of the
shoulder strap.
POWER
SAVE
START/
STOP
REC
ADJ.
POWER
DATE/TIME RES. MEM
COUNTER
OPEN
ON
PUSH
Pull on tab to
remove the lens
cap.
Attach to
lens cap
holder.
Shoulder
strap
rings
POWER
SAVE
START/
STOP
REC
S. MEM
COUNTER
OPEN
ON
PUSH