Filter
Top Products
Remote Control
Battery Installation
The batteries supplied with your remote control are
packed separately. Install them as follows.
1. Turn the remote control over and slide the battery
compartment cover off.
2. Insert the batteries so that their positive (+) ends
contact the positive terminals in the battery
compartment.
3. Replace the cover.
Notes: Never place anything heavy on top of the remote
control or lay it upside-down. This may accidentally
depress the buttons for a long time and discharge the
batteries.
Replace the batteries when the camcorder fails to respond
to the remote control. Remove the batteries from the
remote control if it will not be used for a month or more.
This will prevent possible damage from battery leakage.
If leakage occurs, wipe up the liquid inside the
compartment and replace the batteries with new ones.
Do not use new and used batteries together.
Different brands and types of batteries have different
voltages. Do not use different brands or types of batteries
together.
Remote Control Sensor
The remote control operates the camcorder by
infrared light, so it is protected from electrical and
sound interference. However, the remote control
must be aimed directly at the camcorder’s remote
control sensor. There cannot be any obstructions
between them. The remote control should operate
up to approximately 16 feet from the camcorder.
Replace the remote control batteries if the operation
distance decreases.
Note: The camcorder may not respond to the remote
control if the camcorder’s remote control sensor is
exposed to direct sunlight or strong artificial light.
14
Location and Function of Remote Control
Buttons
A brief description of the functions of the remote
control buttons is given here. Most of the remote
control buttons perform the same function as the
corresponding controls on your camcorder. You
can use whichever are more convenient at the
time.
Note: An RCA VCR that is set to respond to the VCR 2
button on the VCR’s remote control may respond to
this remote control when it is used to operate the
camcorder.
RECORD
STOP
F.FWDPLAYREW
STILL
SCENE SEARCH
COUNTER
DISPLAY
–
+
START
STOP
MEMORY
RESET
REW
F.FWD.
STOP
MODE SEL.
AUTO LOCK
MANUAL FOCUS
ON
OFF
+
–
FOCUS
PLAY
ADJ.
DATE/TIME
RES.
MEM
COUNTER
RECORD
STOP
F.FWDPLAYREW
DISPLAY
START
STOP
1
2
3
4
STILL
SCENE SEARCH
– +
COUNTER
MEMORY
RESET
5
7
6
9
8
(continued on the next page)