Ricoh 06577 Digital Camera User Manual


 
6
97
Appendix
Error Messages
Error Messages Description
Memory card full
The memory card is full and no more
images can be saved. Insert a new
memory card or delete unwanted files.
No image
There are no images that can be played
back on the memory card.
This image cannot be
displayed
You are trying to play back an image
in a format not supported by this camera.
You may be able to play it back on a
computer.
No card in the camera
There is no memory card inserted
in the camera.
Memory card error
The memory card has a problem,
and image capture and playback are
impossible. You may be able to play
it back on a computer.
Failed to initialize the Eye-Fi function
when using the Eye-Fi card. Press E.
Card is not formatted
The memory card you have inserted is
unformatted or has been previously used
on another device and is not compatible
with this camera. Use the card after
formatting it with this camera.
Card is locked
The write-protect switch on the memory
card you have inserted is locked. (p.112)
This image cannot be
magnified
You are trying to magnify an image that
cannot be magnified.
This image is protected
You are trying to delete an image that is
protected. Remove protection from the
image. (p.81)
Not enough battery power
remaining to activate Pixel
Mapping
These messages appear when you try to
perform Pixel Mapping or Sensor
Cleaning, or to update the firmware if the
battery level is insufficient. Install a fully
charged battery.
Not enough battery power
remaining to clean sensor
Not enough battery power
remaining to update the
firmware
Unable to update firmware.
There is a problem with the
firmware update file
Unable to update the firmware. The
update file is damaged. Try downloading
the update file again.
Image folder cannot be
created
The maximum folder number (999) is
being used, and no more images can be
saved. Insert a new memory card or
format the card.
Unable to store image
The image could not be saved because of
a memory card error.
The operation could not be
completed correctly
The camera was unable to adjust the
manual white balance. Try the operation
again.
Failed to authenticate the wireless
function when using the Flucard. Or,
[Reset Transfer Settings] failed when
using an Eye-Fi card or Flucard.
No more images can be
selected
You are trying to select more than the
maximum number of images for the
following functions.
Select & Delete
RAW Development
•Protect
Eye-Fi Image Transfer
Error Messages Description
e_kb558_om.book Page 97 Tuesday, September 16, 2014 11:59 AM