Filter
Top Products
EXTRA OPTIONS
35SAFEGUARD / TOTALGUARD
Key Chain Remote Control KR21 – 2x CR2016 batteries
De KR21 wordt geleverd met volle batterijen. Wanneer de indicator op de KR21 zwak gaat branden, dienen de batterijen
vervangen te worden.
• A new KR21 contains fully charged batteries. If the indicator light on the KR21 is not very bright, the batteries should be
replaced.
• Open the remote control (back) with your nails or a small screwdriver. Use CR2016, 3V lithium batteries (2x).
• To retain the unique code for your remote control, the batteries need to be replaced within 30 seconds.
• If after replacing the batteries the console does not respond to your remote control, press the ARM button on your remote
control for 4 seconds to reactivate the remote. Then release the button. You now need to reregister the remote control, using
the procedure described in 3.1.2.
☺ When pressing the ARM button the LED should flash quickly a few times. When the LED lights up and stays lit, you need to
reactivate the KR21.
☺ To avoid losing a memory space, you can remove the old code for your remote control from the memory (see 8.2).
Comfort Remote Control SH624 – 4x AAA batteries
Wanneer de indicator op de SH624 zwak gaat branden, dienen de batterijen vervangen te worden.
• If the indicator light on the SH624 is not very bright, the batteries should be replaced.
• First set the switch on the front of the remote control to SEC. Now open the battery compartment on the back of the remote
control and replace the batteries within 30 seconds.
• If the console does not respond to your remote control after replacing the batteries, press the PANIC button on your remote
control. You now need to reregister the remote control, using the procedure described in 3.1.2.
☺ To avoid losing a memory space, you can remove the old code for your remote control from the memory (see 8.2).
Door/Window Sensor DS90 – 2x AAA batteries
The console checks the battery status of the DS90 sensor. If the batteries are too weak, the console will indicate a ‘PROBLEM’ and
the zone number will flash.
• Normally the unique code of the sensor will remain in the memory (if you replace the batteries within 30 seconds). After
replacing the batteries you can check whether the sensor still has its unique code. You do this by opening the door or window.
If the sensor has remembered its code, the console display will read ZONE x OPEN (zone number for x). If nothing happens, the
door/window sensor needs to be reregistered (see 4.1.3). Delete zones you do not use anymore (see 9.6) or install the sensor in
the same zone as before.
Motion Detector MS90 – 2x AA batteries
The console checks the battery status of the MS90 sensor. If the batteries are too weak, the console will indicate a ‘PROBLEM’ and
the zone number will flash.
• Normally the unique code of the sensor will remain in the memory (if you replace the batteries within 30 seconds). You can
check this by setting your system to ARMED AWAY. If the sensor has remembered its code, the alarm will go off when you
walk past the sensor. If nothing happens, you need to reregister the motion detector (see 4.2.3). Delete the zone (see 9.7) and
reregister the sensor (see 4.2.3).
20071_20070228_UG_SC9000_EN 08-03-2007 10:07 Pagina 35