Filter
Top Products
100
Connecting/Disconnecting
Setting up a wireless connection to a printer
1
Slide the mode switch to (playback)
(Wireless) Menu [Connect/Disconnect]
See Menus and Settings (p. 32).
Even if you press the button
without displaying the menu in
playback mode, the same screen
will be displayed.
2
After confirming that [1.WA-1] is selected as
the [Target Device], use the or buttons
to select [Connect] and press (or ).
The monitor will display “Connect-
ing”, and soon the connection will
be complete.
If a device other than [1.WA-1] is
selected as the target device, use
the or button to select [Tar-
get Device], then use the or
button to select [1.WA-1].
In situations where a number of wireless print adapters are
available for connection (have been registered as target
devices) (p. 102), select the wireless print adapter you wish
to connect to as the target device.
When the wireless connection starts, the camera’s wireless
lamp and the wireless print adapter’s lamp will both begin to
blink blue. When the wireless connection has been com-
pleted, both lamps will remain on (without blinking).
You can also start a wireless connection without using the
menus by continually pressing the button.
When the wireless connection has been completed, the
icon will display. This shows the strength of the connection’s
radio waves.
If a connection cannot be completed due to weak radio
waves or some other reason, the connection will automati-
cally be terminated after 30 seconds.
For instructions on how to print once you have set up a wireless
connection, please refer to the Direct Print User Guide.