Filter
Top Products
117
List of Messages
Cannot register this image!
You attempted to register an image recorded in a different
camera or a movie as a start-up image.
Protected!
You attempted to erase or edit a protected image, movie or
sound memo.
Too many marks.
Too many images have been marked with print settings, transfer
settings or slide show settings. Cannot process any more.
Cannot complete!
Could not save the print, transfer or slide show settings.
Unselectable image.
You attempted to set the print settings for a non-JPEG image.
Exx
(xx: number) Camera malfunction. Turn the power off and then
back on, then shoot or play back. A problem exists if the error
code reappears. Note the number and contact your Canon
Customer Support Help Desk. If an error code displays directly
after taking a picture, the shot may not have been recorded.
Check image in playback mode.
Connection has failed x
Wireless connection has failed. Please follow the instructions
below corresponding to the number shown in the error message.
1
2
3
An error has occured when you set up a wireless connection to
a computer. Please refer to the Software & Wireless Guide.
4
5
Wireless connection has failed. Either shorten the distance
between the camera and the wireless print adapter; change
the orientation of the camera or the angle of the wireless print
adapter; or change the channel settings. Then establish a
wireless connection again.
7
When a large volume of images (around 3,000) is stored on the
memory card, it may not be possible to establish a wireless
connection. In such a case, use a memory card reader to store
the necessary images in a computer, then reduce the images on
the memory card and try again to establish a wireless connection.