Filter
Top Products
101
Wireless Connection
Ending the wireless connection
If displays during wireless connection, it means that the
connection is very good. The fewer the antennas displayed,
the worse the wireless connection is. When and the
wireless lamp both blink, it indicates an extremely bad
connection. In such a case, shorten the distance between
the camera and the wireless adapter.
Please be aware of the points below when using a wireless
connection between the camera and a printer. Failure to
follow these instructions may terminate the connection.
- Do not use a wireless connection near to a microwave
oven or any other appliance which emits electromagnetic
waves.
- Do not put the camera and the printer far apart.
- Do not place objects in between the camera and printer.
If a number of wireless print adapters are available for
connection, select [Target Device] and press the DISP.
button to confirm which wireless print adapter you can
connect to. The lamp on the available adapter will blink in
the following sequence: blue, blue, orange.
If you slide the mode switch while using a wireless
connection to a printer, the wireless connection will be
terminated.
If you end the wireless connection while printing, printing
will be interrupted.
1
Slide the mode switch to (playback)
(Wireless) Menu [Connect/Disconnect]
See Menus and Settings (p. 32).
2
Use the or button to select [Discon-
nect], then press .
The wireless connection will end.