Filter
Top Products
118
System requirements
For Windows For Macintosh
PC with processor better than
Pentium 450MHz
(Pentium 800MHz recommended)
*
Samsung Converter
PC with processor better than
Pentium III 500MHz (Pentium IV
recommended)
Power Mac G3 or later, or Intel
Processor
Windows 98SE / 2000 / ME /
XP/Vista
*
Samsung Converter
Windows 2000 or later
recommended
Mac OS 10.1 - 10.4
Minimum 128MB RAM
(Over 512MB recommended)
Minimum 256MB RAM
110MB of available hard-disk space
USB port USB port
CD-ROM drive CD-ROM drive
1024×768 pixels, 16-bit colour
display compatible monitor
(24-bit colour display
recommended)
Microsoft Direct X 9.0 or later
MPlayer (For movie clip)
About the software
After inserting the CD-ROM provided with this camera into the
CD-ROM drive, the following window should automatically display.
Before connecting the camera to the PC, you
should fi rst install the camera driver.
Camera driver: This enables images to transfer between the
camera and PC.
This camera uses the USB Storage Driver as the camera driver. You
can use the camera as a USB card reader. After installing the driver
and connecting this camera to the PC, you can fi nd [Removable Disk]
in [Windows Explorer] or [My computer]. A USB Storage Driver is
provided only for Windows. A USB Driver for MAC is not included with the
Application CD. You can use the camera with Mac OS 10.1-10.4.
XviD codec: This makes movie clips (MPEG-4) recorded with
this camera play back on a PC.
To play back a movie clip recorded with this camera, you must install the
XviD codec. If a movie clip recorded with this camera does not play well,
install this codec. This software is only compatible with Windows.