Filter
Top Products
20 – 36x SMART DOME CAMERA
How to use OSD Menu
Display [ON/OFF]
Sets if camera makes mask shows or not on images.
Clear Mask [CANCEL/OK]
Deletes data in the selected mask NO.
Privacy Zone Area Setup
Move camera to area to mask. Then the menu to
adjust mask size will be displayed.
If the tilt angle is located in the range between 90°
to 90°, you can not set up privacy zone mask.
If tilt angle over 90° (image fl ipped region) is
designated, camera will automatically move to
identical poison by changing tilt angle less than 90°
and moving pan angle 180 relatively.
Privacy Zone Size Adjustment
Adjust mask size. Use joystick or arrow buttons to
adjust mask size.
◄► (Left/Right) Adjusts mask width.
▲▼ (Up/Down) Adjusts mask height.
Zoom In/Out Change Color of mask.
To hide a certain zone completely regardless of high
speed PT motions, it is recommended that the size of
mask must be 20% bigger than original target size.
It is noted that during PAN/TILT control like jog
action, the object behind the privacy mask can be
disclosed in a short period of time.
•
•
❖
❖
•
•
•
MOTION SETUP
Setup the general functions of Pan/Tilt motions.
Preset Lock [ON/OFF]
If Preset Lock is set to ON, it is impossible to set up
and delete Preset, APAN, Pattern and SCAN. It is
possible only to run those functions. To set up and
delete those functions, enter into OSD menu.
Power Up Action [ON/OFF]
Refer to “Other Functions”(page 17) section.
Auto Flip [ON/OFF]
Refer to “Other Functions”(page 17) section.
Jog Max Speed [2°/sec ~200°/sec]
Sets maximum jog speed. Jog speed is inversely
proportional to ratio of zoom. As zoom magnifi cation
goes up, pan/tilt speed goes down.
Jog Direction [INVERSE/NORMAL]
If you set this to ‘Normal’, the view in the screen is
moving same direction with jog tilting. If ‘Inverse’ is
selected, the view in the screen is moving reversely.
Freeze in Preset [ON/OFF]
At start point of preset movement, camera starts
freezing the image of start point. Camera keeps
displaying the image of start point during preset
movement and does not display the images which
camera gets during preset movement. As soon as
camera stops at preset end point, camera starts
displaying live images which it gets at preset end
point.
•
•
•
•
•
•
EDIT MASK 1
[ZOOM : COLOR CHANGE]
[◄►:ADJUST MASK WIDTH]
[▲▼:ADJUST MASK HEIGHT]
[NEAR:SAVE / FAR:CANCEL]
MOTION SETUP
PRESET LOCK OFF
PWR UP ACTION ON
AUTO FLIP ON
JOG MAX SPEED 140/SEC
JOG DIRECTION INVERSE
FRZ IN PRESET OFF
<PARKING ACTION SETUP>
<ALARM INPUT SETUP>
BACK
EXIT
EDIT MASK 1
MOVE TO TARGET POSITION
[NEAR:SELECT/FAR:CANCEL]
0/0/x1/N