Filter
Top Products
24 – 36x SMART DOME CAMERA
How to use OSD Menu
Edit Pattern
① By using Joystick, move to start position with
appropriate zoom. To start pattern recording,
press NEAR or ENTER key. To exit this menu,
press FAR key.
② Move camera with joystick of controller or run
preset function to memorize the path (mostly
curve path) in a selected pattern. The total
memory size and the rest memory size is
displayed in the form of bar. Maximum 1,000
communication commands can be stored in a
pattern.
③ To save data and exit, press NEAR or ENTER
key. To cancel recording and delete record
data, press FAR key.
❖
SCAN SETUP
Scan Number [1~8]
Selects Scan number to edit.
If a selected Scan number is not defi ned,
“UNDEFINED” will be displayed under selected Scan
number.
Clear Scan [CANCEL/OK]
Deletes data in current Scan
Edit Scan Starts editing Scan.
Edit Scan
① Press NEAR or ENTER key in “NO” list to start
Scan setup.
② Note that MAX. 20 Functions are allowed in a
Scan. Move cursor up/down and press NEAR
or ENTER key to set up.
•
•
•
❖
EDIT PATTERN 1
MOVE TO START POSITION
[NEAR:START/ FAR:CANCEL]
0/0/x1/N
EDIT PATTERN 1
[NEAR:SAVE / FAR:DELETE]
0/0/X1/N
SCAN SETUP
SCAN NO. 1
UNDEFINED
CLEAR SCAN CANCEL
<EDIT SCAN>
BACK
EXIT
EDIT SCAN 1
NO. ACTION NO. DWELL OPT
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
SAVE
CANCEL [NEAR:EDIT]
EDIT SCAN 1
NO. ACTION NO. DWELL OPT
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
SAVE [NEAR:EDIT ACT]
CANCEL [FAR :EDIT END]