Samsung VP-D190MSI Camcorder Accessories User Manual


 
ENGLISH
93
Troubleshooting
Troubleshooting
Before contacting a Samsung authorized service centre, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
Self Diagnosis Display
Moisture Condensation
If the camcorder is brought directly from a cold place to a warm place, moisture may condense inside the
camcorder, on the surface of the tape, or on the lens. In this condition, the tape may stick to the head drum
and be damaged or the unit may not operate correctly.
To prevent possible damage under these circumstances, the camcorder is fitted with a moisture sensor.
If there is moisture inside the camcorder, (DEW) is displayed. If this happens, none of the functions
except cassette ejection will work.
Open the cassette compartment and remove the battery pack.
Leave the camcorder for at least two hours in a dry warm room.
slow
slow
no
slow
slow
slow
slow
the battery pack is almost discharged. Change to a charged one.
When the remaining time on the tape is
about 2 minutes.
Prepare a new one.
the tape reached its end.
Change to a new one.
there is no tape in camcorder.
Insert a tape.
the tape is record protected.
If you want to record, release
the protection.
moisture condensation has formed in
the camcorder.
see below.
the camcorder has some mechanical
fault.
1.Eject the tape.
2.Set to OFF.
3.Detach the battery.
4.Reattach the battery.
* If unresolved contact your
local service representative.
TAPE END!
TAPE END!
TAPE!
PROTECTION!
....
D
L
C
R
Display
Blinking Informs that... Action