Filter
Top Products
10
ENFORCER Mini PTZ Camera
SECO-LARM, U.S.A., INC.
a
Pre-operation Checklist
Before operating this PTZ camera, please note the following:
Double-check that the cables are properly run between the controller and camera, and that all connections are
correct.
Double-check that the camera ID on the controller is the same as the ID of the target camera. The camera ID can
be found by looking at the camera ID DIP switch settings (see page 8).
The Pelco protocol setting of the controller and the camera must be identical. The Pelco protocol setting of the
camera can be found by looking at the communication protocol setup DIP switch settings (see page 8).
Make sure that the camera was rebooted after any of the camera ID or communication protocol setup DIP
switches are changed.
Refer to the controller or DVR manual for information on configuring or operating those devices.