SECO-LARM USA EV-7105-PPEQ Security Camera User Manual


 
29
ENFORCER Mini PTZ Camera
SECO-LARM, U.S.A., INC.
PATTERN SETUP Menu
From DOME CAMERA SETUP
PATTERN NO.
1
UNDEFINED
CLR PATTERN
CANCEL
<EDIT PATTERN>
PATTERN SETUP
EXIT
BACK
Configures up to four pan/tilt patterns, with each pattern consisting of a
starting position, an ending position, and the complete pan/tilt/halt movement
between those two points .
PATTERN NO
[1 ~ 4]
Selects which PATTERN number to edit. If the
selected PATTERN number has not yet been
programmed, "UNDEFINED" will be displayed
under the selected PATTERN number.
CLR PATTERN
[CANCEL / OK]
Choose "OK" to delete the data in the selected
PATTERN
<EDIT PATTERN>
Goes to the "EDIT PATTERN" menu. See below.
EDIT PATTERN Menu
From PATTERN SETUP
1. Use the joystick or arrow keys to move the camera view to the
appropriate starting position for the pattern, and set the
desired zoom.
To start the pattern recording, press the NEAR key. To exit this
menu without saving the pattern, press the FAR key.
EDIT PATTERN 1
[NEAR:START /FAR:CANCEL]
MOVE TO START POSITION
2. Use the joystick or arrow keys to move the camera along the
desired path until the end. As the camera is moving, the path
is being saved into its memory.
Note: While setting the PATTERN, any time the camera
pauses will also be saved as part of the pattern.
The total memory size and available memory is displayed on
the screen as a bar.
3. To save this pattern, press the NEAR key. To cancel the
recording of the PRESET pattern, press the FAR key.
EDIT PATTERN 1
0 / 0 / x 1 / N
[NEAR:SAVE /FAR:DELETE]