Filter
Top Products
27104AF
24
4. PTZ SETUP MENU
4.1 HOME
After a dome control menu item has been selected, follow the directions below to set the function.
The HOME function can be set so that the camera automatically goes to Preset, Tour, Pattern, or Auto Scan after the
OpenEye Keyboard Controller has been idle for an amount of time. For example, if a joystick controller is idle for 10
seconds (FUNCTION TIME), the camera goes to the previous mode.
Folow these steps to program the Home Function:
1. Select MENU to display the main menu on the monitor. Select HOME menu and enter the menu.
2. You can select the Home Function by pressing the PST, TOUR, PTRN, or SCAN button on your OpenEye
Keyboard controller.
3. After selecting the number, move the function number (Each function has maximum numbers). For example, you
can have 319 Presets, 8 Tours, 4 Patterns and 8 Auto Scan options. (You can call only saved items)
4. Select Function Time (Select from 10 to 240 seconds)
5. Select Function Mode AUTO/MANUAL (In AUTO Mode, the dome returens to the previous task after completing
the HOME FUNCTION)
6. SAVE and EXIT
HOME
SYS INFO
DISPLAY
DOME SETUP
ALARMS
--- OpenEye OPTIX PRE-PACK ---
CAMERA
CONFIG
LANGUAGE
EXIT
HOME FUNCTION
FUNCTION NUMBER
FUNCTION TIME(SEC
FUNCTION MODE
SAVE EXIT
HOME FUNCTION SETUP
:HOME
:
:010
:AUTO