Filter
Top Products
27104AF
29
D. VIEW ANGLE
Note: When the dome camera is installed near a wall, panning range can be programmed by users.
Flip - Allows the dome camera to automatically turn 180 degrees when the camera tilts to its lower position.
Once the camera reaches the floor along a moving object, it willstop.
Over Tilt - The defaut limit is 80 degrees for TiIt angle. When this mode is on, you can see up to 90 degrees.
PAN LIMIT(ON/OFF): Off - When the dome camera is installed near the wall, PAN LIMIT can be programmed by
user to avoid the area obsured by the wall.
E. POSITION
If the OpenEye OPTIX OSD is obsured on other equipment, like a DVR, you can move the OSD horizontally
and/or vertically. The factory position is 33/05 (Horizontal/Vertical). Variable 23~43 for horizontal, 02~15 for vertical.
4. PTZ SETUP MENU
HOME
SYS INFO
DISPLAY
DOME SETUP
ALARMS
--- OpenEye OPTIX PRE-PACK ---
CAMERA
CONFIG
LANGUAGE
EXIT
PRIVACY ZONE
AREA TITLE
OSD DISPLAY
VIEW ANGLE
POSITION
COOLER/HEATER
VIEW ANGLE SETUP
FLIP (ON/OFF)
OVER TILT (ON/OFF)
PAN LIMIT (ON/OFF)
PAN RIGHT LIMIT
PAN LEFT LIMIT
MIRROR/REVERSE
SAVE EXIT
: ON
: OFF
:
:
:
: OFF
MIRROR/REVERSE: Off - Normal image, H - MIRROR: Left-right reversal of the image, V-MIRROR: Upside down
image, REVERSE: Left - right reversal and Upside down.
HOME
SYS INFO
DISPLAY
DOME SETUP
ALARMS
--- OpenEye OPTIX PRE-PACK ---
CAMERA
CONFIG
LANGUAGE
EXIT
PRIVACY ZONE
AREA TITLE
OSD DISPLAY
VIEW ANGLE
POSITION
COOLER/HEATER
OSD POSITION SETUP
HORIZONTAL POSITION
VERTICAL POSITION
SAVE EXIT
:33
:05
WARNING
THIS FEATURE AFFECTS
PRIVACY ZONE