Filter
Top Products
27104AF
6
IMPORTANT SAFEGUARDS
1. Do not expose the camera to rain or moisture -
The OPTIX camera itself is designed for enclosed
use or for use in a location where it is protected from
rain and moisture. When exposed to moisture, turn
the power off immediately and ask a qualified service
personnel for servicing. Moisture can damage the
camera and also create the danger of electric shock.
2. Do not install this camera upside down -
This camera is designed for mounting on the ceiling
or wall.
If you install this camera upside down, for example,
mounted on the floor, it may cause malfunction.
3. Do not attempt to disassemble the camera -
To prevent electric shock, do not remove screws or
covers.
There are no user serviceable parts inside.
Ask a qualified service personnel for servicing.
4. Avoid placing the camera in direct sunlight -
Do not aim the camera at bright objects.
Whether the camera is in use or not, never face
the unit towards direct sunlight or other extremely
bright objects. Otherwise blooming or smearing may
be caused.
5. Do not use strong solvents or detergents -
Use a dry cloth to clean the camera when it is dirty. If
it is hard to remove the dirt on the camera, use a mild
detergent and wipe it gently.
6. Handle the camera with care -
Do not abuse the camera. Avoid striking, shaking, etc.
The camera could be damaged by improper handing
or storage.
7. Before operating, please check proper
temperature, humidity and power source ratings -
-Use the camera under conditions where temperature
is between 0C - 45C and humidity is below 60%. The
input power source is 24VAC 850mA.
8. Do not use the camera in such places as shown
below. The lens may become cloudy due to
condensation if the camera is used under the
following conditions -
- Rapid temperature fluctuation by switching an air
conditioner on and off.
- Rapid temperature fluctuation due to frequent door
opening and closing.
- Used in an environment where eyeglasses become
foggy.
- Used in a room filled with cigarette smoke or dust.
If the lens becomes cloudy due to condensation,
remove the dome cover and wipe all moist surfaces
with a soft cloth.
9. Consumables -
Parts having contacts such as the lens-drive motors,
cooling fan motor and slip-rings built inside the camera
are subject to wear with time.
For information on the replacement and maintenance
of such parts, please ask the nearest service center.