Filter
Top Products
Chapter 1 Overview
Chapter 1 Overview 25
Rear and Bottom
1 TALLY (back tally)indicator (red)
This indicator lights during recording.It will not light if
the TALLY switch 2 is set to OFF.This indicator also
blinks to indicate warnings in the same manner as the
REC/TALLY indicator in the viewfinder.
6 WRR connector
Note
Use a jitterless LTC signal.Using an LTC signal
reproduced by other equipment may cause the
camcorder to malfunction.
4 TC OUT (time code output) connector (BNC)
This outputs time code signals from the built-in time
code generator.When a time code signal is input to the
TC IN connector (3 on page 24), this output signal is
synchronized to it.
For details about time code, see “Setting Time Values” on
page 62.
5 S VIDEO OUT (S-video output) connector (DIN
4-pin)
This outputs the image being shot or played back as S-
video signals.Connect to the S-video input connector
on an external VCR or video monitor.
6 MONITOR OUT (output) connector
Outputs the image being shot or played back as
composite video signals.Connect to the video input
connector on an external VCR or video monitor.
Note
The output signal from this connector may discontinue
when switching the operation between recording and
playback.Do not use as a reference video signal for
external equipment.
7 AUDIO OUT CH-1/CH-2 (audio output channel
1 and 2) connectors (phono jacks)
These output the sound being recorded or played back.
Connect to a stereo amplifier or video monitor’s audio
input connectors.
1 TALLY indicator
2 TALLY switch
3 Battery attachment
interface
4 DC IN connector
5 AUDIO IN CH-1/CH-2
connectors and input
selection switches
7 Cable clamp
8 DV OUT connector
9 DC OUT connector
0 VTR connector
qa BREAKER button
2 TALLY switch
Set this switch to ON to activate the TALLY indicator
1 function.
For details, see “Warning System” on page 127.