Filter
Top Products
66 Chapter 3 Shooting
Chapter 3 Shooting
Setting Time Values
Synchronization With External Time Code Signals — Gen-Lock
Connection for gen-lock
Connect the reference video and time code signals to the camcorder as shown below.
Locking the video and time code signals to an external reference signal
Locking the video and time code signals to
another camcorder’s video and time code
signals
Using one camcorder as reference, to its video and
time code signals, lock the other camcorders’ video
Note
Synchronization with external time code signals (by
gen-lock) may be disallowed in some cases at
ClipLink shooting. For details, see step 4 on page 69
in “ClipLink Shooting”
To edit and compile a recording that is shot using
multiple camcorders, it is necessary to synchronize the
video and time code of the various camcorders (by
gen-lock).
GEN LOCK IN
Reference video signal
TC IN
Reference time code signal
Composite video signal (used as reference video signal)
Time code signal (used as reference time code signal)
GEN LOCK IN
TC IN
Reference camcorder
Locked camcorder
VIDEO OUT
a)
TC OUT
TC OUT
VIDEO OUT
a)
a) The output signal from the MONITOR OUT connector on the DSR-500WSL/500WSPL may discontinue when
switching the operation between recording and playback. Use the output signal from the VIDEO OUT connector.
and time code signals.
If the reference camcorder is gen-locked to an external
reference signal, any other connected camcorders are
gen-locked to the same reference signal.