Filter
Top Products
You can check the last port_onof a scene you JUSt recorded without changing the setting of
the POWER switch using EDITSEARCH.
1
Put the camcorder in the standby mode by
pressing the START/STOP button.
D
8TART I STOP
2
Press the - _ side of EDITSEARCH momentarily.
The last few seconds of the recorded portion will be
played back inthe viewfinder.After a few seconds of
playback, the camcordergoes back to the standby
mode, ready for the next recording.
Note on using EDITSEARCH
When you raise the viewfinder and use EDITSEARCH,
hold the viewfinderwith yourthumb to prevent
movement.
+ EDITSEARCH --(_
,'_,- " - EDITSEARCH
You can check the recorded picture in the vlewfinder using EDITSEARCH. Sound cannot
be monitored.
1
Press the small green button, and slide
the POWER switch to CAMERA.
Set the STANDBY switch up.
START I STOP
3
Keep pressing the + or - side of EDITSEARCH to
view the playback picture:
+ side for the playback picture
- side for the playback picture inreverse.
+ EDITSEARCH - (_
To stop playback
Release EDITSEARCH.
To monitor the sound while viewing the playback picture in the viewfinder
1 Connect an earphone to the @ (earphone) jack.
2 Press the small green button and slide the POWER switch to PLAYER.
3 Press _ to rewind the tape and press 2 where you want to stop.
4 Press D to start playback.
6 Advanced Camera Operat=on