Filter
Top Products
Dunng recora_ng or playback, the d_g_ts on the counter indicate the actual recording or
playback t_me.
To count the whole tape
Press COUNTER RESET at the begfnnng of the tape so that the counter shows "0:00 00".
Write down the counter reading at a partqcular point so that you can easily find that point
later by refernng to the tape counter.
To return to a preset point
ii _I i -"-- L 4
,- ,2
1
During playback, press COUNTER RESET
at the point you later want to locate.
The counter shows "0:00:00".
COUNTERRESET
% °
2
3
Press [] when the playback has finished, as usual.
Press ZERO MEM.
The "ZERO MEM" md,cator blinks in the
viewfinder
Be sure to press ZERO MEM after you
stop the tape. It does not function during
recording or playback
ZEROMEM
%
STOP
REW
Press <1<1or IH_. I_
The tape rewinds or advances and stops automatically
when the counter reaches approximately zero.
Notes on the tape counter and the ZERO MEM button
• Someth,ng must be recorded on the tape m order for the tape counter to funchon
The tape counter will not work on blank tape
• The counter reading and the point of the tape may not correspond exactly Use the counter as a
guide
There w_ll be a bme lag of several seconds especially when you repeat fast-forward running/
rewinding and play back the tape recorded _nLP and SP modes m_xed
• The ZERO MEM mode _s cancelled automatically once the tape _s rewound or sent forward to the
pofnt where you pre-regrsfered
6 Advanced Camera Operation