Filter
Top Products
Beforeyoucanusethiscamcorder,youneedtochargeandnstallthebatterypack
1
2
1 Plug the AC power adaptor into a wall outlet.
2 Align the flat side of the battery pack with the line on the AC power adaptor.
3 Push down and slide the battery pack in the direction of the arrow
4 Set the CHARGE/VTR switch to CHARGE.
Required charging time:
Type of battery pack NP-55 NP-77H/
(supplied) NP-77HD
Required charging time 60 140
NP-77 NP-66H NP-55H
1'20 100' 7D '
(approx minutes using AC-V35/V35A'
When charging is finished, the charge indicator will go out.
Important!
Use the battery completely before recharging!
Before you recharge the battery, make sure the battery has been used (discharged)
completely. Excessive charging may reduce the charging capacity of the battery.
To use up the battery, remove the video cassette and set the POWER switch to
CAMERA with the battery attached, and leave the camcorder until the ,F_\_indicator
appears blinking and a red lamp blinks in the viewfinder.
Option AC-S10 AC power adaptor.
This adaptor has a functionwhich allows you to confirm that the battery is completely discharged and
ready to be recharged to its full capacity.
_rnt- : illi'r_ h_:]ll.'F1 iP3"_J _"_ ,'IB
When you have hnlshedcharging the battery, installthe battery pack as follows.
6 Getting Started