Filter
Top Products
89
Additional Information
The { and 6 indicators flash and no
functions except for cassette ejection
work.
The battery pack is quickly
discharged.
The battery remaining
indicator does not indicate
the correct time.
In the recording and playback modes
Symptom Cause and/or Corrective Actions
• The battery pack is not installed, or is dead or nearly dead.
m Install a charged battery pack. (p. 8, 9)
• The AC power adaptor is not connected to a wall outlet.
m Connect the AC power adaptor to a wall outlet. (p. 11)
•The tape was ejected after recording.
•You have not recorded on the new cassette yet.
• The operating temperature is too low.
• The battery pack is not fully charged.
m Charge the battery pack again. (p. 9)
• The battery pack is completely dead, and cannot be
recharged.
m Replace with a new battery pack. (p. 8)
• You have used the battery pack in an extremely hot or
cold environment for a long time.
• The battery pack is completely dead, and cannot be
recharged.
m Replace with a new battery pack. (p. 8)
• The battery is dead.
m Use a charged battery pack. (p. 8, 9)
• The power source is disconnected.
m Connect it firmly. (p. 8, 11)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 8, 9)
• Moisture condensation has occurred.
m Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize. (p. 94)
In the flash memory function
Symptom Cause and/or Corrective Actions
• The STANDBY switch is not set to MEMORY.
m Set it to MEMORY. (p. 58)
• The built-in flash memory has already been recorded to its
full capacity.
m Erase unnecessary images and record again. (p. 70)
• The image is protected.
m Cancel image protection. (p. 70)
(Continued on the following page)
Troubleshooting
The power does not turn on.
The end search function does not
work.
Recording does not function.
The cassette cannot be removed from
the holder.
The image cannot be deleted.