Filter
Top Products
13
Getting started
, Close the inner cover and slide
it in the direction of the arrow
to lock it.
Close the inner cover while holding the
batteries in. Make sure the cover is closed
securely.
To remove the batteries
Perform steps 1 and 2 and remove the
batteries.
• Be careful not to drop the batteries when
opening or closing the inner cover.
, Inspect the waterproof cover.
Inspect the O-ring and the O-ring mating
surface for scratches, deformation, dirt, hair
or other problems.
• Note that if the O-ring and the O-ring mating
surface are damaged, dirty or have other
problems, the waterproof performance may be
impaired. In this case, water may enter the
inside of the camera and cause irreparable
damage.
• Replace the O-ring with a new one if it
becomes scratched or deformed, or after
approximately two years of use even if there are
no problems (page 81).
, Close the waterproof cover.
Close the waterproof cover and slide the
slide lock lever back into place until the
OPEN button clicks.
• When using the camera underwater or in places
exposed to water, slide the lock switch (page 9)
to lock the waterproof cover. This prevents the
waterproof cover from opening by accident.
4
5
O-ring
O-ring mating
surface
6