Filter
Top Products
19
Shooting still images
, Close the inner cover and slide
it in the direction of the arrow
to lock it.
Make sure the cover is closed securely.
To remove a “Memory Stick”
Perform steps 1 and 2, and push the
“Memory Stick” to pop it out. When doing
so, be careful not to drop the “Memory
Stick.”
• When the access lamp is lit up, it means
that image data is being read or written.
Never open the inner cover or turn off
the power at this time, as the data may
be damaged.
, Inspect the waterproof cover.
Inspect the O-ring and the O-ring mating
surface for scratches, deformation, dirt, hair
or other problems.
• Note that if the O-ring and the O-ring mating
surface are damaged, dirty or have other
problems, the waterproof performance may be
impaired. In this case, water may enter the
inside of the camera and cause irreparable
damage.
• Replace the O-ring with a new one if it
becomes scratched or deformed, or after
approximately two years of use even if there are
no problems (page 81).
, Close the waterproof cover.
Close the waterproof cover and slide the
slide lock lever back into place until the
OPEN button clicks.
• When using the camera underwater or in places
exposed to water, slide the lock switch (page 9)
to lock the waterproof cover. This prevents the
waterproof cover from opening by accident.
4
Access lamp
5
O-ring
O-ring mating
surface
6