Filter
Top Products
39
Advanced operations
Using alternative power sources
Charging the attached battery pack
After connecting the power cord to the wall outlet and setting the POWER switch on
the digital camcorder to OFF, you can charge the battery pack in either of the following
two ways:
•Charging the battery pack attached to the digital camcorder
Leave the battery pack attached to the digital camcorder. (The NP-F950 battery pack
(not supplied) requires about 390 minutes for a full charge and about 330 minutes for
a normal charge.)
While charging, the battery indicator appears repeatedly in the display window:
•Charging two battery packs at the same time
Attach one battery pack to the AC power adaptor and the other to the digital
camcorder. Both are charged simultaneously. When charged, CHARGE lamp and the
ı indicator goes out (normal charge). If either lamp is still lit, both battery packs are
not charged (the NP-F950 battery packs (not supplied) require about 480 minutes for a
full charge and about 420 minutes for a normal charge).
To remove the adaptor
Pull out by the plug. Never pull on the connecting cord itself.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected
to the wall outlet, even if the set itself has been turned off.
Notes on the VTR/CAMERA lamp
•The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
•If the VTR/CAMERA lamp does not light, disconnect the power cord. After about one
minute, reconnect the power cord.
This mark indicates that this product is a genuine accessory for Sony
video products.
When purchasing Sony video products, Sony recommends that you
purchase accessories with this “GENUINE VIDEO ACCESSORIES”
mark.