Filter
Top Products
90
Trouble check
If you run into any problem using the digital camcorder, use the following table to
troubleshoot the problem. Should the difficulty persist, disconnect the power source
and contact your Sony dealer or local authorized Sony service facility.
Digital camcorder
Power
Symptom Cause and/or Corrective Actions
• The battery pack is not installed.
m Install the battery pack. (p. 23)
• The battery is dead.
m Use a charged battery pack. (p. 21)
• The AC power adaptor is not connected to a wall outlet.
m Connect the AC power adaptor to a wall outlet. (p. 38)
• While being operated in CAMCORDER mode, the digital
camcorder has been in Standby mode for more than 5
minutes.
m Turn STANDBY down once and then up again. (p. 26)
• The battery is dead.
m Use a charged battery pack. (p. 21)
• The ambient temperature is too low. (p. 85)
• The battery pack has not been charged fully.
m Charge the battery pack again. (p.21)
• The battery pack is completely dead, and cannot be
recharged.
m Use another battery pack. (p. 85)
Operation
Symptom Cause and/or Corrective Actions
• The tape is stuck to the drum.
m Eject the tape. (p. 25)
• The tape has run out.
m Rewind the tape or use a new one. (p. 36)
• CAMCORDER/VTR is set to VTR.
m Set it to CAMCORDER. (p. 26)
• The tab on the cassette is out (red).
m Use a new tape or slide the tab. (p. 25)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 21, 38)
• Moisture condensation has occurred.
m Remove the cassette and leave the digital camcorder for
at least 1 hour. (p. 86)
• The battery is weak or dead.
m Replace the battery with a new one. (p. 79)
The power is not on.
The power goes off.
The battery pack is quickly
discharged.
START/STOP does not operate.
The cassette cannot be removed
from the holder.
{ and 6 indicators flash and no
function except for cassette
ejection works.
The time code is flashing in
display window.