Filter
Top Products
91
Additional information
Trouble check
Symptom Cause and/or Corrective Actions
• CAMCORDER/VTR is set to CAMCORDER.
m Set it to VTR. (p. 36)
• The tape has run out.
m Rewind the tape or use a new one. (p. 36)
• The digital camcorder is updating the cassette memory
data (only for DVCAM cassettes with cassette memory).
m Eject the cassette after the C MEMORY indicator
disappears (p. 25).
• STEADY SHOT is set to OFF.
m Set STEADY SHOT to ON. (p. 68)
• FOCUS is set to MANU.
m Set it to AUTO. (p. 53)
• Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANU to focus manually. (p. 52)
• LINE/MIC is set to LINE.
m Set it to MIC FRONT or MIC REAR.
• DIRECTION SELECT is set to 0°.
m Set it to 90° or 120°. (p. 29)
• The signal of recording tape is no condition to operate
audio dubbing.
m Dub the tape into another DVCAM cassette in Fs 32k
using A/V connecting cable. (p. 29)
• The picture has been recorded with BUILT-IN MIC set to
WIND.
m When there is no wind, set it to off (green position).
(p. 67)
• AUDIO MIX in the menu is set to ST2.
m Set it to ST1. (p. 40)
• Reset the date and time. (p. 80)
• Set DIGITAL F in the menu to OVERLAP. (p. 40)
• Set DIGITAL F in the menu to ZOOM/WIDE. (p. 40)
• Set DIGITAL F in the menu to ZOOM/WIDE. (p. 40)
(to be contunued)
The tape does not move when a
video control button is pressed.
The Steady Shot function does not
activate.
The autofocusing function does
not work.
The microphone does not work
while recording.
Built-in microphone sound does
not record in stereo when
monitoring by headphone or line
out jacks.
Audio dubbing does not work.
Excessive high-pitched sound is
heard when recording using the
built-in microphone.
The recording sound is weak or is
not heard.
The date and time indicator
disappears.
The overlap function does not
work.
D ZOOM or 16:9WIDE mode in
the menu system cannot be set to
ON.
The slow shutter does not work.