Filter
Top Products
49
nN
Using the Network Media Receiver - general settingsNetwork Media Receiver
5 Highlight OK, then press the SELECT button.
The Network Media Receiver prepares to download the firmware update.
The POWER/REC indicator starts blinking (red) slowly.
6 On your VAIO computer, start the update tool and begin updating the system software of the Network Media Receiver.
During the download, the POWER/REC indicator starts blinking rapidly.
Do not unplug the AC power cord or the network cable during the download.
When the update is completed, the Network Media Receiver goes into Standby mode.
! Once you have started the firmware update process, do not attempt to stop or cancel it. All buttons on the remote control are disabled during the update.
✍ All settings except for the IP address are reset to the default settings, once the update is completed. The firmware update takes approximately three minutes to complete.
Check the Sony VAIO-Link website: http://www.vaio-link.com, for future firmware updates.