Filter
Top Products
Preparation
Accessing the Camera Using the Web Browser
11
Tip
The factory setting of the camera network is as
follows.
IP address: 192.168.0.100
Subnet mask: 255.0.0.0
Wireless LAN setting
Type: Adhoc
SSID: snc-rz50
Channel: 11 ch
WEP: Nothing
IP address: 10.0.0.100
Subnet mask: 255.0.0.0
The welcome page of the network camera is
displayed on the web browser.
Note
If the IP address is not set correctly, the welcome page
does not appear after step 12. In that case, try to set the
IP address again.
Accessing the Camera
Using the Web Browser
After the IP address has been assigned to the camera,
check that you can actually access the camera using the
Web browser installed on your computer.
Use Internet Explorer as the Web browser.
1
Start the Web browser on the computer and type the
IP address of the camera in the URL box.
The welcome page is displayed.
2
Click Enter.
The main viewer is displayed.
If the main viewer is displayed correctly, accessing
the camera is confirmed.