Filter
Top Products
Others
Using the SNMP
47
the <string> position. The maximum length of
<string> is 255 characters.
3) sysName=<string>
Set the instance of “mib-2.system.sysName.0” in
the <string> position. The maximum length of
<string> is 255 characters.
4) enaAuthTraps=<value>
Set the instance value of “mib-2.snmp.snmp
EnableAuthenTraps.0” in the <string> position.
Type “1” (enable) or “2” (disable) in the <value>
position.
5) community=<ID>,<rwAttr>,
<communityName>,<IpAddressString>
Set the community name and the reading/writing
attributes. <ID> describes the setting identification
number (1 to 8), <rwAttr> describes a character
representing the reading/writing attribute (“r”, “R”,
“w or “W”), <communityName> describes the
community name to be set, and <IpAddressString>
describes the IP address of the host you allow the
access (0.0.0.0 for any host).
Example: To allow reading/writing any host in the
“private” community and having the ID number
“2”.
community=2,w,private,0.0.0.0
6) trap=<ID>,<communityName>,
<IpAddressString>
Set the host you want to send traps to. <ID>
describes the setting identification number (1 to 8),
<communityName> describes the community
name to send traps to, and <IpAddressString>
describes the IP address of the host to send traps to.
Example: To specify the destination of traps as the
private community and the ID number “1”.
rap=1,public,196.168.0.101
7) delcommunity=<ID>
This parameter is used to delete the previous
community setting. <ID> describes the community
setting identification number (1 to 8).
8) deltrap=<ID>
This parameter is used to delete the previous setting
of the host to send traps to. <ID> describes the trap
setting identification number (1 to 8).
When you have finished changing the SNMP setting
information, check the changed settings using an inquiry
command. If the changed settings are OK, restart the
SNMP using the following CGI command. Be careful
that by entering the command, the camera enters the
restart mode.
SNMP restart command
<Method>
GET, POST
<Command>
http://ip_adr/snmpdconf/snmpdconf.cgi?
snmpd=restart