Filter
Top Products
Administrating the Camera
Configuring the Network — Network Menu
47
WPA and WPA2 use TKIP and AES encryption
systems. This unit supports TKIP for WPA, and AES for
WPA2.
Authentication
Select the authentication method.
PSK: Select for PSK authentication. When this option is
selected, Passphrase setting is required.
EAP: Select for EAP authentication. When this option
is selected, enabling the 802.1X (wireless) function
is required. After selecting EAP, click OK at the
bottom of the window. Then the 802.1X function is
enabled.
Note
For correct operation of the 802.1X function, you need
to configure the 802.1X settings, such as certificate
setting, appropriately. For details on the 802.1X settings,
see “Using the 802.1X Authentication Function —
802.1X Menu” on page 49.
802.1X
This button is active when EAP is selected on
Authentication.
When you click 802.1X, the 802.1X menu appears,
allowing you to configure the 802.1X (wireless)
function.
Passphrase
Set a passphrase when PSK is selected on
Authentication.
Type 8 to 63 ASCII characters (alphanumeric), or up to
64 hexadecimal digits (0 to 9 and A to F).
Re-type passphrase
To confirm the passphrase, retype the passphrase that
you typed in the Passphrase box.
OK/Cancel
See “Buttons common to every menu” on page 30.
Dynamic IP address notification
Tab — Notifying the IP Address
When Obtain an IP address automatically (DHCP) is
selected in the Network tab or Wireless tab, you can
send notification of completion of the network settings
using the SMTP or HTTP protocol.
e-Mail (SMTP) notification
Select On to send an e-mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server for
sending an e-mail, using up to 64 characters.
Authentication
Select the authentication required when you send an e-
mail.
Off: Select if no authentication is required when an e-
mail is sent.
On: Select if authentication is required when an e-mail
is sent. Select one of the authentication methods
from the following and specify the POP server
name, User name and Password as required.
SMTP: Select when SMTP authentication is
required.
POP before SMTP: Select when POP before SMTP
authentication is required.
Note
When you set Authentication to On, make sure to select
either or both SMTP or/and POP before SMTP.