Filter
Top Products
63
Editing
Adding an audio sound on a recorded tape
(1) Insert your recorded tape into your camcorder.
(2) Set the POWER switch of your camcorder to VTR.
(3) Locate the recording start point by pressing N. Then press X at the point
where you want to start recording to set your camcorder to playback pause
mode.
(4) Press AUDIO DUB on the Remote Commander .
(5) Press X on the Remote Commander and at the same time start playing back
the audio you want to record.
The new sound is recorded in stereo 2 (ST2) during playback.
(6) Press x on the Remote Commander at the point where you want to stop
recording.
Monitoring the new recorded sound
To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in the MENU settings (p. 72).
Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (ST1) only. The factory setting
is original sound only.
VTR SET
H i F i SOUND
AUD
I
O M
I
X
RETURN
[
MENU
] :
END
ST1 ST2