Filter
Top Products
Operation
Loading the Paper Roll and Ink Ribbon
13
4
Place the paper roll in the paper cartridge.
Caution
• Since the thermal head is still very hot just after
printing is finished, be careful not to touch the
thermal head when placing the paper roll in the
paper holder. Touching the thermal head may
burn you.
• Do not place the paper roll on any part of the
printer other than the paper cartridge. Doing so
may damage the printer. Especially do not place
it on the thermal head.
5
Remove the tape attached at the center of the paper
roll.
6
While holding both ends of the paper roll, insert the
paper roll into the paper cartridge. Feed in the paper
with your hand until the marking hole becomes
blue.
Note
Turn the paper roll while pushing it with both hands
so that the paper roll does not loosen.
Notes
• Be sure to remove all of the pieces of tape
attached to the paper roll. A seal remaining inside
the printer may cause problems.
• Do not touch the printing surface of the paper roll
in the paper holder after loading it. Sweat or dirt
from your hands, or folded paper may have an
influence on the quality of the printout.
7
Push the paper cartridge back in as it was.
Thermal head
Marking hole
Turn the paper roll until the marking hole
becomes blue, while pushing it with both
hands so that the paper roll does not
loosen.