Filter
Top Products
81
GB
Table of
contents
Sample
images
Menu Index
The setting is reset without the resetting operation.
• The battery pack was removed when the power switch was set to ON. When removing the battery
pack, make sure the camcorder is turned off and the access lamp is not illuminated.
The camcorder does not work properly.
• Turn off the camcorder. Remove the battery pack and attach it again. If the camcorder is hot, remove
the battery pack, and allow it to cool down before trying this corrective procedure.
• If the AC Adaptor is used, disconnect the power cord. Connect the power cord and turn on the
camcorder again. If the camcorder does not work after doing these solutions, consult your Sony dealer
or local authorized Sony service facility.
“--E-” is indicated on the screen.
• Remove the memory card, and insert it again. If this procedure does not turn off the indication, format
the memory card (page 69).
“Recovering data. Please wait...” is indicated on the screen, and recording stops.
• Recording and deleting data has been repeated too many times on the memory card, or the memory
card was formatted on another device. Save the data on the hard disk of a computer, etc., first, and
then format the memory card using your camcorder (page 69).
• The writing speed of the memory card you are using is not fast enough to accommodate the recording
speed of movies of your camcorder. Use one of the recommended memory cards (page 87).
Nothing appears on the LCD monitor and viewfinder of the camcorder.
• When the camcorder is connected to a computer or another device using the USB cable, nothing
appears on the LCD monitor and viewfinder. This is not a malfunction. The screen turns on when the
device is disconnected.