Filter
Top Products
26
External Control Commands
■ Help of the Date Setting
[Command] setup date -
-help
[Process] Displays the help of the Date Setting
command.
Note
You can set the DATE settings when NTP setting is
set to off.
When NTP setting is set to on, the following
messages are displayed.
setup date 10-01-2006<CR>
warning: NTP mode is currently set to
on; please turn it off to
manually set the date.<CR>
Time Settings
■ Time Settings
[Command] setup time
TIME
[Parameter] TIME: HH:MM:SS
[Process] Sets the time.
<Example> Setting the time to 15:00:00
setup time 15:00:00<CR>
setup save complete time<CR>
Note
Time Setting is available only when the NTP Setting
is set to OFF.
When the NTP Setting is set to ON, the following
message appears.
setup time 15:00:00<CR>
warning: NTP mode is currently set to
on; please turn it off to
manually set the time.<CR>
■ Current Time Setting
[Command] setup time
[Process] Displays the current time.
■ Help of the Time Setting
[Command] setup time -
-help
[Process] Displays the help of the Time Setting
command.
Web Monitor Settings
■ Web Monitor Settings
[Command] setup web
MON/RATE/SIZE/QUA
[Parameter] MONitor: on, off
frame RATE: 1 to 5 (1 step)
view SIZE: 320, 160
image QUAlity: 1 to 10 (1 step)
[Process] Sets the Web monitor.
<Example> Example of the Web monitor settings
setup web on/2/320/5<CR>
setup web complete<CR>
■ Current Web Monitor Setting
[Command] setup web
[Process] Displays the current web monitor
setting.
■ Help of the Web Monitor Setting
[Command] setup web -
-help
[Process] Displays the help of the Web Monitor
Setting command.
Camera Administrator: CDS Gain Settings
■ CDS Gain Settings
[Command] cds
GAIN
[Parameter] GAIN: 0 to 63 (1step)
[Process] Sets the CDS gain manually.
<Example> Example of the CDS gain setting
cds 63<CR>
camera cds complete<CR>
■ Auto CDS Gain Settings
[Command] cds
AUTO
or
cds
AUTO X Y
[Parameter] AUTO: auto
X: x-coordinate of the start point of the
rectangular area of the image data to
be used for adjustment
Y: y-coordinate of the start point of the
rectangular area of the image data to
be used for adjustment
*The size of the rectangular area of the
image to be adjusted is 160 × 128 for
the XCI-SX1 and 80 × 64 for the XCI-
V3. You are allowed to not input the X
and Y parameters. (When the X and Y
parameters are not input, the
rectangular area of the image data to
be used for adjustment is the center of
the image area.)
[Process] Sets the CDS gain automatically.
<Example> Adjusting the CDS gain automatically
using the x-coordinate and y-
coordinate of the top left point of the
rectangular area
cds auto 560 448<CR>
camera cds complete<CR>
■ Current CDS Gain Setting
[Command] cds
[Process] Displays the current CDS gain setting.
■ Help of the CDS Gain Setting
[Command] cds -
-help
[Process] Displays the help of the CDS Gain
Setting command.