Symbol Technologies P 300STD Photo Scanner User Manual


 
2-119
Programming the Scanner
Intercharacter Delay
Note:
This parameter is available only on the P 300FZY.
Select the intercharacter delay option matching host requirements. The intercharacter delay
gives the host system time to service its receiver and perform other tasks between characters.
The delay period can range from no delay to 99 msec in 1-msec increments. After scanning
the bar code below, scan two bar codes beginning on page 2-120 to set the desired time-out.
If you make an error or wish to change your selection, scan
CANCEL
on page 2-122.
Intercharacter Delay
Convert Control Characters
When enabled, this parameter converts special control character sequences to their
corresponding keycodes. It converts the <CTRL> M, <CTRL> I, and <CTRL> [ sequences to
<Enter>, <Tab>, <Backspace>, and <Esc> respectively.
Note:
This parameter is available on the P 300FZY only.
Disable Convert Control Character
Enable Convert Control Character