Filter
Top Products
2-123
Programming the Scanner
Macro PDF Features
This section discusses programmable Macro PDF features fully supported by the P 300PRO
scanner. Macro PDF is a special feature for concatenating multiple PDF symbols into one file.
The P 300PRO can decode symbols that are encoded with this feature.
Caution
When printing, keep each Macro PDF sequence separate, for each sequence
has unique identifiers. Do not mix bar codes from several Macro PDF se-
quences, even if they encode the same data. When scanning Macro PDF se-
quences, scan the entire Macro PDF sequence without interruption. If you
scan a mixed sequence, you get two long low beeps (Lo Lo) for inconsistent
file ID or inconsistent symbology error.
Before programming these special features, follow the physical setup instructions in
Chapter
1, Getting Started
. Then program the required generic decode and data transmission
parameters using the bar codes on the following pages. Use the same programming method
for setting Macro PDF features as used for standard features.
Note that all parameter settings are stored in non-volatile memory and so are retained after
powerdown.