Filter
Top Products
17
Dome Cable Definition and Requirements
For operation, the IP dome camera requires a network cable to carry the video signals to
the remote viewing site and a power cable to power the dome. The IKS-WP806 IP
camera is capable of using Power over Ethernet + or 24vAC power.
Cable Requirements: 24vAC Power
Power Wire Length Specifications
Wire
Gauge
Maximum
Distance
Wire
Gauge
Maximum
Distance
22 27 feet 14 175 feet
20 44 feet 12 279 feet
18 69 feet 10 444 feet
16 110 feet
Note Ensure that the power supply corresponds with the dome’s power requirement
or the camera may be damaged. Contact a qualified maintenance engineer
with any problems.
Power Connection
1. Connect one 24 volt AC power to pin AC1.
2. Connect frame or earth ground wire to the middle pin.
3. Connect one 24 volt AC power to pin AC2.
Note The ‘notches’ on the left side of the graphic above
correspond to notches in the green plastic of the power connector.
Note Be careful not to pull the cables improperly during installation. Toshiba
suggests that you fasten the cables after installation is complete.
Grounding Recommendation
The GND (ground) wire must be directly connected to the middle pin of the AC24V
power connector. Failure to connect the ground can cause damage and failure of the
camera and may void the warranty.