Filter
Top Products
21
INSTALLATION
You can install your IKS-WP806 using the included Hard Ceiling Mount or Pendant
Mount.
Installation with Hard Ceiling Mount
1. Mark the positions of the three screw holes in
the Hard Ceiling Mount at your chosen
location.
2. Drill each hole using a 3/16” bit.
3. Set the included screw anchors in the holes,
and then screw the self-tapping screws into the
anchors.
4. Run the Data Cable and Ethernet cable
through the center hole of the mount and
connect the cable to the camera.
5. The cables can be run through a hole drilled in
the ceiling, or through the gap in the side of the
camera.
6. Install the camera onto the Hard Ceiling Mount
by lining the camera up with the tabs, then
turning the camera clockwise.
7. Tighten the screw on the side of the camera to
secure this position.
Installation with Indoor Pendant Mount
1. Thread the necessary cables through the
center hole of the pendant mount and connect
them to the camera.
2. Attach the camera to the pendant mount by
lining up the tabs and then turning the camera
clockwise.
3. Tighten the screw on the side of the camera to
secure it to the pendant mount.
4. Attach the pendant mount to the pole or other
implement as necessary.