Filter
Top Products
38
QoS (Quality of Service)
Quality of Service allows you to prioritize network traffic services of the camera’s
functions. The QoS function utilizes the Differentiated Services prioritized using
Codepoint values (DSCP).
Note Routers and switches on the network must be QoS or DSCP capable, and
have these settings enabled for this function to operate on your network.
DSCP Settings
The DSCP value range is 0 to 63. The default value is 0, which indicates the function is
disabled; and rates 1 as the highest priority, and 63 as the lowest priority.
Video DSCP: prioritize video streaming over HTTP or RTSP
Audio DSCP: prioritize audio streaming
Management DSCP: prioritize web interface traffic over HTTP
SNMP
With Simple Network Management Protocol (SNMP) enabled, the camera can be
monitored and managed remotely with a network management system. Contact your
network administrator if you are not familiar with SNMP setup.
SNMP v1/v2
Enable SNMP v1
Enable SNMP v2
Read Community: Specify the community name that has read-only access.
Write Community: Specify the community name that has read/write access.
Traps for SNMP v1/v2
Traps are used to send a message to the network management system for important
events or status changes.
Enable Traps: enables trap reporting
Trap Address: enter the IP address of the network management system
Trap Community: enter the community to use when sending trap messages