Filter
Top Products
50
Triggered Action
Once motion detection has been fine tuned, the Triggered Action can be configured if
you want the camera to take one of these actions upon sensing motion.
Enable Alarm Output – Select to trigger the alarm output on the camera on motion
detection.
Record Stream to SD Card – Select this option to record to an internally installed
SD card when this alarm is activated.
Send Alarm Message by FTP/E-Mail – Select to send an alarm message by FTP
and/or E-Mail when this alarm is activated.
Upload Image by FTP/E-Mail – Select to send an image by FTP and/or E-Mail
when this alarm is activated.
Send HTTP Notification – Select to send a notification to a HTTP server.
Note E-Mail, FTP, and HTTP options will also need to be configured within their
corresponding menus. See the Mail, FTP or HTTP sections previously in this
manual for more details.
File Name – Enter a file name in the box (the examples below used “image.jpg” for the
file name). The uploaded image’s file name format can be set in this section. Please
select the one that meets your requirements.
Add date/time suffix
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix will end at the number being set. For example, if the setting is
up to “10”, the file name will start from 00 and end at 10, and then start all over
again.
Overwrite – The original image on the FTP site will be overwritten by the new
uploaded file with a static filename.