Filter
Top Products
Installation and Operation Guide
35
Frame rate: Click on the drop-down list to choose the frame rates of “5FPS”, “10FPS”,
“15FPS”, “24FPS” or “(25) 30FPS”.
Format: Click to choose the “MJPEG” or the “MPEG4” mode.
Fine Tune mode:
White Balance: Scroll to choose the mode from “Auto”, “Fluorescent (3200K)”, “Indoor
(4200K)”, “Outdoor (6500K)”, ”Push Hold”.
Flickerless: Mark the “Flickerless” “ON” or “OFF”. Click your choices to enable.
Mirror: Mark the “Mirror” “ON” or “OFF”. Click your choices to enable.
High Speed Shutter: Mark the “High Speed Shutter” “ON” or “OFF”. Click your choices to
enable.
BLC Mode: Scroll to choose from “Disable”, “Weighted” or “Fixed Gain”.
Backlight: Select in the backlight level in the blank (0 to 255).
Brightness: Select your desired quality of image brightness from a spectrum of 0 to
255.
Contrast: Select the contrast level in the blank (0 to 255).
Saturation: Select the saturation level in the blank (0 to 255).
Sharpness: Select the sharpness level in the blank (0 to 255).
MJPEG mode:
Viewer type: Click to choose the viewer type of the “ActiveX” or “AJAX” mode.
MJPEG Deinterlace: Click to choose the MJPEG Deinterlace of the “ON” or “OFF” mode.
Submit: Click to submit the new image setting to the IP camera.
Default: Click this button to install the default settings in all the entries for image
parameters on this page.