Filter
Top Products
68 Installation and Operation Guide
6. ADVANCED OPERATION
Question 1:
How can I view the live images of the IP camera via Microsoft Internet Explorer on the
Desktop PCs, or the laptop computers, in a situation where there are no monitors or
television?
◇To get the IP address of the IP camera without a monitor, use one of the following two methods
to get the IP address: UPnP and IP function.
UPnP: Please refer to APPENDIX 1.
IP function: Please refer to APPENDIX 2.
Question 2:
How do I set up the motion detection area and its sensitivity?
◇Set up the motion detection
1. Click the Application button in the home page.
2. Click the Motion detection button on the left side of the page to enter the “Alarm – Motion
Detection” page.
3. Click and drag the cursor across a targeted zone to draw a red rectangle on the image. You
can also draw the other targeted zones as you wish.
4. Please Enable the motion detection function.
5. Set up the sensitivity level from: Lowest, Low, Medium and High to Highest.
6. Click the Submit button to submit the setting.
Question 3:
How do I record on the SD card for 30 seconds when the motion has been activated and
use Microsoft Internet Explorer to view the recorded files?
◇Recording the images into an SD card while the motion detection function is working
1. Click the Application button in the home page.
2. Click the Enable button below the ALARM item on the left side of the page to enter the
“Alarm Application Enable Setting” page.