Filter
Top Products
64
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television equipment reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Move the equipment away from the monitor.
• Plug the equipment into an outlet on a circuit dierent from that to which the monitor is connected.
• Consult the dealer or an experienced radio/television technician for additional suggestions.
CAUTION! Any changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
RF EXPOSURE INFORMATION
The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm
(7.9”) from all persons and must not be collocated or operating in conjunction with any other antenna or
transmitter.
IC COMPLIANCE INFORMATION
RADIO EQUIPMENT NOTICE
The term “IC:” before the radio certication number only signies that Industry Canada technical
specications were met. Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device. “Privacy of communications may not be ensured when using this device”.
CE COMPLIANCE INFORMATION
Products with CE Marking comply with EMC Directive (2004/108/EC); Low Voltage Directive (73/23/EEC);
R&TTE(1999/5/EC) issued by the Commission of the European Community. Compliance with these directives
implies conformity to the following European Norms:
• EMC: EN 301 489
• LVD: EN 60950
• Radio: EN 300 328