Filter
Top Products
10
Typical Mounting Methods
The UBCT9 can be conveniently mounted on a table, bulkhead, overhead, or any other
desired location with the supplied mounting bracket (refer to gure below for typical
mounting methods).
Caution: Make sure there are no hidden electrical wires or other items behind the
desired location before proceeding. Check that free access for mounting and
cabling is available.
• Table top mount • Bulkhead mount • Overhead mount
Mounting the Scanner in Your Vehicle
Before you mount the scanner, make sure you have all the necessary materials. Then
conrm that the scanner ts your vehicle’s mounting area. This unit requires a mounting
area of 50.8mm high by 176.5mm wide by 153.6mm deep.
Caution: Be sure to avoid obstructions behind the mounting surface.
Follow these steps to mount the scanner in your vehicle.
1. Choose a mounting location, then use the supplied
mounting bracket as a template to mark the positions
for the mounting screw holes.
2. In the marked positions, drill holes slightly smaller
than the supplied screws.
3. Attach the mounting bracket to the mounting location
using the supplied screws and lock washers.
4. Attach the scanner to the mounting bracket using the
supplied mounting knobs.
5. Connect the antenna’s cable to the ANT. connector
on the rear of the scanner.
Note: If the antenna cable’s connector does not t in
the ANT connector, you might also need a
Motorola-to BNC antenna plug adapter
(available at a local electronics store).
UBCT9 OM 10 12/11/07 3:52:53 PM