Filter
Top Products
21
Private Bank Scanning
Programming Frequencies into Channels
Before the scanner begins Private Bank scanning, you must program a frequency into at
least one channel. Visit our website (www.uniden.com.au, www.uniden.co.nz) for
information on known frequencies. Frequencies for Australia can be found on the
Australia Scanner Frequencies CD included with the UBCT9.
You will need to program each frequency into the scanner’s channels in order to hear these
frequencies.
1. Press
HOLD/RESUME and enter the channel
number where you want to store a frequency by
using the keypad, then press
HOLD/RESUME.
or Change the channel by using the or key.
2. Enter the frequency you want to store by using the
keypad and
(decimal key).
3. Press
E to store the frequency into the channel.
4. If you want to program another frequencies into the
channel, select another channel by using the or
key.
Note: •
To clear a mistake while entering the frequency, press (decimal key)
repeatedly until the display is cleared.
• If you enter a invalid frequency, an error tone will sound and “Error” appears
on the display. To clear the Error message immediately, press
(decimal key).
• Even if you don’t enter full numbers as a frequency number, the scanner will
automatically select the nearest valid frequency.
Deleting a Stored Frequency
To delete a stored frequency:
a. Select a channel.
b. Press
0.
c. Then press E.
Note: Channels with no frequencies are automatically locked out.
SCAN
SCAN
SCAN
UBCT9 OM 21 12/11/07 3:53:39 PM