Filter
Top Products
28
Storing Search Frequencies
You can quickly store any frequency you nd during Search.
1. During Search, press HOLD/RESUME. If you want
to change the frequency, use the or key to
move up or down 1 frequency step. Then press E. Or
when the scanner stops on the frequency you want
to store, press E.
2. Select a bank you want to store by using the keypad.
The smallest empty channel number and the
frequency alternately appear on the display. If
necessary, you can also change the channel by
using the keypad, the or key.
3. Press E.
Note: • If the frequency you want to store exists already in a bank, you will hear an error
tone and other channel appears on the display. (See “Duplicate Frequency Alert”
on page 22.)
• After storing the frequency, it moves to the Search Hold mode.
• If there is no free channel, the frequency you want to store will automatically be
stored in the rst channel in the selected bank.
4. Press to resume searching.
Delay
To help prevent missing a reply on a specic channel or frequency, you can program a two
second delay into any channel, frequency, service band or band search. When scan or
search stops on a channel or frequency, there is a two-second pause before the scanning
cycle resumes.
To activate the Delay feature (in either Scan mode or Search mode):
1. For State Scan mode or Private Scan mode, when in Hold mode, select the desired
frequency or channel and then press DELAY. Or when the scanner stops on an active
frequency or channel, quickly press DELAY before it continues scanning again.
––– OR –––
1. For Search mode, while searching press DELAY.
2. “DLY ” will appear on the display.
UBCT9 OM 28 12/11/07 3:53:45 PM